There are things you can do prior to sending a job to us to be die cut to ensure your project goes off without a hitch. Here are a few suggestions to help you achieve this. Gripper Always make sure there is enough gripper on the sheets you are sending over to be die cut. The minimum gripper needed for our equipment is 1/2”, if there is room it should be 3/4”. This especially applies when multiple up sheets are being trimmed down to be cut 1 up. Stock Letting us know what stock you are going to use prior to printing helps us when building a die, especially if it’s going to have folds in it. Creasing rule (score) height plays a big role in making sure the scores don’t crack and the piece folds properly. The rule heights that go into a die are determined by the stock …